ALIBI ALI-BC5011VF Szybka instalacja i instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Szybka instalacja i instrukcja obsługi dla Kamera IP ALIBI ALI-BC5011VF. ALIBI ALI-BC5011VF 3 stron. Hd-tvi 1080p varifocal 230’ ir bullet camera

Drukuj stronę
CLEANING
Clean the camera dome with an approved glass cleaning solution and a lint free cloth.
Dust can be removed from the unit by wiping it with a soft damp cloth. To remove stains, gently rub
•
the surface with a soft cloth moistened with a mild detergent solution, then rinse and dry it with a
soft cloth.
Remove all foreign particles, such as plastic or rubber materials, attached to the camera housing.
•
These may cause damage to the surface over time.
Do not use benzene, thinner or other chemical products on the camera assembly; these may
dissolve the paint and promote damage of the surfaces. Before using any chemical product,
CAUTION
carefully follow the accompanying instructions.
TROUBLESHOOTING
Problem
Possible Cause
Nothing appears on the screen
- Check the power connection.
- Check the video signal cable connection to the monitor.
The video image is dim or not clear.
- If the camera lens is dirty, clean it with a soft, clean cloth.
- Adjust the monitor controls, if necessary.
- If the camera is facing a very strong light, change the camera position.
- Adjust the lens focus.
The screen is dark.
- Adjust the contrast control of the monitor.
- If you have an intermediate device, set the impedance (75 Ω / Hi-Z)
properly, and check the cable connections.
The camera is not working properly and
- Verify that the camera is correctly connected to an appropriate regulated
the surface of the camera is hot.
power source.
The image on the monitor flickers
- Make sure that the camera isn't facing direct sunlight or fluorescent light.
If necessary,change the camera position.
SPECIFICATIONS
Model
IMAGE SENSOR
EFFECTIVE PIXEL
SCANNING SYSTEM
SYNCHRONIZATION
HORIZONTAL RESOLUTION
VIDEO OUTPUT
S/N (Y Signal)
MIN. ILLUMINATION
IRIS ADJUSTMENT
LENS
ELECTRONIC SHUTTER
www.observint.com
3
ALI-BC5010VR
ALI-BC5011VR
1
/
" 2.1 megapixel Sony Exmor CMOS
2.9
1920 (H) × 1080 (V) = 2.07 megapixels
Progressive
Internal
1080p
TVI, CVBS : 1.0 Vp-p, 75Ω composite
More than 52 dB
0.02 lux (Sens-UP X32)
ALC / ELC
2.8 ~ 12 mm DC Auto Iris
6 ~ 50 mm DC Auto Iris
Varifocal Lens (ICR type)
Varifocal Lens (ICR type)
AUTO (1/30 ~ 1/60,000)
Model
OSD LANGUAGE
BACKLIGHT COMPENSATION
DAY & NIGHT
DIGITAL WIDE DYNAMIC RANGE
(D-WDR)
AUTO GAIN CONTROL
WHITE BALANCE
PRIVACY MASKING
DIGITAL NOISE REDUCTION (DNR)
SMART IR
LENS SHADING COMPENSATION (LSC)
ADAPTIVE CONTRAST/COMPENSATE
ENHANCER (ACCE)
GAMMA
DEFOG
DIGITAL ZOOM
DEAD PIXEL COMPENSATION (DPC)
SENS-UP
MOTION
DIGITAL EFFECT
IR LED
WEIGHT
INPUT VOLTAGE
HEATER OPERATION
POWER CONSUMPTION
OPERATING TEMP. / HUM.
STORAGE TEMP. / HUM.
Dimensions
ALI-BC5010VR
ALI-BC5011VR
ENG / CHN / CHN[S] / JPN / KOR
OFF / HLC / BLC / WDR
COLOR / BW / EXTERN / AUTO
OFF / LOW / MIDDLE / HIGH
LEVEL (0 ~ 20) adjustment
AUTO / AUTODEXT / PRESET / MANUAL
On / Off (programmable, 16 zones)
OFF / LOW / MIDDLE / HIGH
ANTI-SET (0~20) adjustment
OFF / ON
OFF / LOW / MIDDLE / HIGH
0.45 / 0.5 / 0.55 / 0.6 / 0.65
OFF / LOW / MIDDLE / HIGH
OFF / ON (x1 ~ x8.0)
LIVE DPC / DPC SET
0FF / X2~X32
4 area
OFF / V-FLIP / MIRROR / ROTATE
8 pcs
2.14 LB (0.972 KG)
12 Vac or 24 Vac
Internal temperature. Off: 68 ˚F. On: -4 ˚F
Heater off, DC IR off: 210 mA (max) / DC IR on : 430 mA (max)
Heater on, DC IR off : 330 mA (max) / DC IR on : 560 mA (max)
Heater off, AC IR off : 200 mA (max) / AC IR on : 350 mA (max)
Heater on, AC IR off : 310 mA (max) / AC IR on : 450 mA (max)
14 ˚F ~ 122 ˚F (-10 ˚C ~ +50 ˚C) / max 90% RH
-4 ˚F ~ 140 ˚F (-20 ˚C ~ +60 ˚C) / max 90% RH
3.6" (92 mm)
10.3" (262 mm)
© 2015 Observint Technologies. All rights reserved.