Bernzomatic QUICKFIRE 3301 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Narzędzia Bernzomatic QUICKFIRE 3301. Bernzomatic QUICKFIRE 3301 6 stron.

Drukuj stronę
ASSEMBLY
1.
Before attaching cylinder, make sure valve is closed by turning adjustment knob (1) clockwise until it stops. Hand tighten only. Do
not force.
2.
Hold torch so that burner tube (3) is pointed away from persons and flammable materials. Thread gas cylinder into regulator/
torch body. Hand tight only. Do not force.
3.
Check all joints and couplings periodically to insure against loose connections. With valve closed, without lighting, test all connec-
tions with soapy water. If bubbles appear, gas is leaking and torch must be repaired or replaced. NEVER USE A FLAME TO CHECK
FOR LEAKS. Conduct this test in a well ventilated and spark-free area and where there are no open flames.

LIGHTING AND OPERATION

CAUTION: Tipping the gas cylinder more than 60 degrees from its upright position may cause torch to flare. The torch has
a built-in regulator that controls pressure and reduces the risk of pulsating or yellow flames when used other than upright. It is
recommended to start working with a disposable hand torch cylinder at room temperature and to keep torch upright as much as
possible.
1.
Open valve fully by turning adjustment knob (1) counter clockwise until it stops. Do not force. Always fully open valve when light-
ing to prevent damage to ignition system. Ensure the safety lock is disengaged by sliding it off the lock icon. Never look into the
burner tube (3) or point in unsafe direction.
2.
Point the torch in a safe direction and pull the ignition button (2) toward you. Repeat if necessary.
3.
After the torch lights the igniter button (2) may be released and the flame may be adjusted by turning the adjustment knob (1).
4.
To avoid possible damage to the ignition system, do not operate the ignition button (2) while the torch is operating.
5.
To stop torch, close regulator valve by turning adjustment knob (1) fully clockwise until it stops. Do not force.
6.
To prevent accidental ignition, engage safety lock when not in use by sliding the safety lock button to the lock icon.

ADDITIONAL WARNINGS

•
Make sure the torch is cool before installing or removing cylinder and accessories. Using the torch with a low flame can cause
damage to the burn tube and ignition system.
•
Check all joints and couplings periodically to insure against loose connections. With valve open, without lighting, test all
connections with soapy water. If bubbles appear, gas is leaking and torch must be repaired or replaced. NEVER USE A FLAME TO
CHECK FOR LEAKS. Make this test in a well ventilated and spark-free area and where there are no open flames.
•
In cold weather the size of the flame will be smaller. To produce a larger flame, pre-warm the cylinder to room temperature prior
to use.
STORAGE – REMOVE CYLINDER FROM TORCH WHEN NOT IN USE
1.
Make sure valve is closed by turning flame adjustment knob (1) fully clockwise until it stops. Hand tighten only. Do not force.
2.
When torch is cool, disconnect cylinder and store torch and cylinder separately and out of reach of children. Observe cautions
on cylinder label.
3.
Do not expose cylinders to temperatures in excess of 120 °F.
4.
Store cylinders in well ventilated areas.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET CES INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES
200 Old Wilson Bridge Road
Columbus, OH 43085
ASSEMBLY
LIGHTING AND OPERATION
STORAGE
442199
BERNZOMATIC.COM
0723