Avanti WD001 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Dozownik wody Avanti WD001. Avanti WD001 12 stron. Hot and cold water dispenser

You can solve many common water dispenser problems easily, saving you the cost of a

possible service call. Try the suggestions outlined below to see if you can solve the problem

before calling the servicer.

PROBLEM

Water dispenser does not operate.

Water cooler is not cold enough.

Water dispenser hot water is not hot enough.

Compressor turns on and off frequently.

Vibrations.

The water dispenser seems to make too much

noise.

Bottle feels warm.

Water bottle is hot.

PROBLEMS WITH YOUR WATER DISPENSER?

POSSIBLE CAUSE

Not plugged in.

The circuit breaker tripped or a blown fuse.

Check to be sure the cold switch on the back is ON.

The water dispenser does not have the correct

clearances.

Cooling coils at the back of the unit need to be cleaned.

Check to be sure the hot switch on the back is ON.

Thermostat may be tripped. Contact Customer Service

for additional instructions.

The room temperature is hotter than normal.

The water dispenser does not have the correct

clearances.

Check to assure that the water dispenser is level.

The rattling noise may come from the flow of the

refrigerant, which is normal.

As each cycle ends, you may hear gurgling sounds

caused by the flow of refrigerant in your water dispenser.

Contraction and expansion of the inside walls may

cause popping and crackling noises.

The water dispenser is not level.

The water system is overfilled. Dispense Cold water until

air is released into the bottle.

Water is boiling in the hot tank and bubbling up into the

bottle. Press the hot dispenser button until water flows to

remove air from the hot tank.