Avantone Pro CLA-200 Podręcznik - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik dla Wzmacniacz Avantone Pro CLA-200. Avantone Pro CLA-200 8 stron. Studio reference amplifier, class a/b 200 watts per channel, 500w mono
Drukuj stronę
a TS connector the minus signal is automatically grounded. A pass-through
connection is provided for convenience when running multiple amplifiers on
the same signal chain.
HOT (+)
COLD (-)
SHIELD
(ground)
•
VOLTAGE SELECT and AC MAINS INPUT: There is a switch on the rear
panel for selecting the proper AC/MAINS operating voltage for your
location. Please be sure to use the correct specified fuse value for your
location. Fuse tray is incorporated into the IEC320 receptacle on the rear
panel.
•
GROUND LIFT Switch: By engaging this switch the pin 1 shield is lifted at
the input jack and routed through two opposing diodes. This can be used to
aid in ground loop control of the incoming analog line signal. The diode
signal path still provides a safety ground in the event of very high voltage
ground loops. The earth ground from the AC input is always connected. If
the ground lift switch doesn't help, it may be necessary to evaluate your
power/ground scheme to eliminate noise issues.
•
SPEAKER OUTPUTS: both SPEAKON™ and binding posts are provided.
In mono/bridge operation mode, the two positive terminals are driven anti-
phase. DO NOT GROUND any of the speaker terminals in bridge mode.
•
MODE SWITCH: DO NOT ADJUST THIS SWITCH WITH POWER ON.
This switch allows the user to operate the amplifier in three modes:
o
STEREO: both channels driven separately
o
DUAL MONO: the input is sent to both outputs; volume controls
are still enabled for each channel
o
BRIDGED MONO: both channels operate together as a single
amplifier. Channel A is the input, and Channel A output is in phase,
channel B output is out of phase.
CONNECTING YOUR CLA-200
Before plugging in and powering up your CLA-200 please take a moment
to be certain that the proper AC MAINS operating voltage setting has been
selected on the rear panel.
XLR
TRS
Pin 2
Tip
Pin 3
Ring
Pin 1
Sleeve (shield)
RCA or TS
Tip
--
Sleeve (shield)