avantor VWR VC100 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler avantor VWR VC100. avantor VWR VC100 19 stron. Controller vacuum

3.2 Operation

3.2.1 Instrument preparation

•

The instrument should be place on a stable surface and well ventilated without any

flammables or explosives.

•

Ensure that the label indicated the correct voltage before connecting the device to

power supply.

•

Ensure that the power socket is grounded properly.

•

Connects the lines of the instrument, vacuum pump and load properly.

•

Connects the power cable of the vacuum pump to the instrument and turn ON the

vacuum pump switch.

•

Connect the power cable of the instrument properly, and turn ON the Power switch.

3.2.2. Startup interface description

Button name

VENT

PROGRAM

SETTINGS

START

Fig. 3.2.1

Function introduction

Gently touch VENT to vent air and lift it to stop

venting.

Choose the control mode and set the control pressure

value and running time.

Set the delay time to open and close the pump

and valve, set the local atmospheric pressure, adjust

the

pressure sensor calibration parameters.

Gently touch it to start the control program, with the