AIRFUSION LD-CD52BN/AB Podręcznik - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik dla Wentylator AIRFUSION LD-CD52BN/AB. AIRFUSION LD-CD52BN/AB 19 stron.

Note: The pairing of Transmitter and Receiver is not required if only one Ceiling fan is installed. When

more than two ceiling fans are installed near each other, please refer to the instruction above.

Fig. 13.

Remote Control Buttons

○

1 FAN SPEED CONTROL BUTTON:

press the button to turn on the fan and control the ceiling fan

speed from low to high.

○

and

VI button is for the fastest speed.

NOTE: when you turn on the fan at first, you need to wait for

several seconds, and then the fan will speed up.

○

2 FAN OFF BUTTON:

Press the button to turn the fan off

○

3 REVERSE FUNCTION BUTTON:

Press the button to active reverse running function.

○

4 LIGHT CONTROL BUTTON: (Not applicable for this model)

○

5 LIGHT MODE SWITCH: (Not applicable for this model)

Slide the switch to "ON" position for light supporting dimming function. Slide the switch to "D" position for CFL.

THE RECEIVER PROVIDES THE FOLLOWING LEVEL OF PROTECTIONS AGAINST.



Lock position: the receiver has a built in safety feature to protect against obstruction during operation. The

motor will be locked from operation and will disconnect from power after 30 seconds of interruption. Please

remove obstacles before re-starting. To reset, simply turn off the power supply to the fan motor and re-start.



Over 80W protection: when the receiver detects power consumption which is greater than 80W, the receiver

power will be stopped and operation will immediately discontinue. Turn the receiver power on after 5

seconds to restart the fan.

○

I button is for the lowest speed,

Fig. 14