Jancy Engineering Slugger MCCS14 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przecinak Jancy Engineering Slugger MCCS14. Jancy Engineering Slugger MCCS14 16 stron. 14" metal cutter
Drukuj stronę
getting started (
.)
cont
WARNING: Cut material can be thrown. Eyes can be permanently damaged.
Wear your safety goggles.
ADJUSTMENTS
Down stop adjustment: The down stop should be adjusted so that
maximum cutting capacity is maintained and so that the cut off
blade does not hit the saw base or the surface which the tool is
mounted to.
1. Lower motor head until the arm hits the down stop.
2. Verify maximum cutting capacity and that there is no contact
between cut off blade and base or mounting surface.
3. If contact occurs, adjust down stop screw and jam nut until
problem is corrected.
CHANGING THE BLADE
1. Disconnect the machine from the power source.
2. Loosen the 3 screws (A), and rotate the saw blade cover (B).
3. Press arbor lock (C) and at the same time rotate blade (G) with
8mm hex wrench in arbor screw until the arbor lock engaged.
4. Using the 8 mm hex wrench provided, loosen arbor screw (D)
by turning it counter clockwise, and remove arbor screw (D),
washer (E), outside blade flange (F) and blade (G). Do Not
Remove Inside Blade Flange.
5. Make sure the inside surfaces of both the inside and outside
blade flanges are clean and free from any debris.
6. lnstall new blade (G) making certain teeth of saw blade are
pointing down at the front and re-assemble outside blade
flange (F), washer (E) and arbor screw (D). Turn arbor screw (D)
clockwise to tighten while pressing spindle lock (C).
7. Replace saw blade cover that was removed in STEP 2.
8. WARNING: MAKE SURE ARBOR LOCK (C) IS DISENGAGED
AND 8 MM HEX WRENCH IS REMOVED FROM ARBOR SCREW
BEFORE TURNING ON THE POWER.
8