Jancy Engineering JB2400 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt budowlany Jancy Engineering JB2400. Jancy Engineering JB2400 16 stron.

Improperly connecting the grounding wire can result in the risk of electrical

shock. Check with a qualified electrician if you are in doubt as to whether

the outlet is properly grounded. Never remove the grounding prong from

the plug. If the cord or plug is damaged, have it repaired before using. If the

plug does not fit the outlet, have the proper outlet and/or plug installed by

a qualified electrician. The Jancy Slugger Bender must be plugged into an

appropriate outlet, properly installed in accordance with all codes and ordi-

nances. The plug and outlet should look like those in Figure A.

This machine is designed to run on either 110 or 220 volts. Operating this machine on voltage other than that

stated on the machine will increase the risk of fire, and/or personal injury.

110 Volt machines must be plugged into a circuit that is controlled by a minimum 25 Amp circuit breaker.

220 Volt machines must be plugged into a circuit that is controlled by a minimum 15 Amp circuit breaker.

Failure to use the minimum rated circuit breakers will increase the risk of fire, and/or personal injury.

Use only 3-wire extension cords, that have 3-prong grounding-type plugs and 3-pole receptacles that accept

the machine's plug. Replace or repair damaged cords before use. Make sure your extension cord is in good

condition. When using an extension cord, be sure to use one heavy enough to carry the current your product

will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating the

machine. Jancy recommends using a minimum 12 gauge extension cord not to exceed 50 feet.

grounding instructions

WARNING!