Lexmark C 752 Instrukcja usuwania zacięć - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja usuwania zacięć dla Drukarka Lexmark C 752. Lexmark C 752 5 stron. Optional envelope drawer
Również dla Lexmark C 752: Podręcznik użytkownika (4 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja usuwania zacięć (2 strony), Skrócona instrukcja obsługi (3 strony), Instrukcja instalacji (16 strony)
Clearing mailbox, finisher, or
output expander jams (Area M)
1
Open the rear door of the 5-bin mailbox or
output expander.
2
Pull the jam straight out, and then close the
door.
Clearing fuser jams
1
Clear the paper path. If the jam error message
persists, go to step 2.
2
Open both the upper right and the lower right
access doors (Areas K and L).
CAUTION:
The fuser assembly may be hot. Let
it cool before continuing.
3
Pull down the latches. They slide toward the
center to release the fuser.
4
Pull the fuser out, and set it on a clean, flat
surface.
5
Unsnap the housing and set it aside.
6
Lift up the fuser roller cover and remove the
jam.
7
Close the fuser roller cover.
8
Snap the housing back onto the fuser.
9
Insert the fuser back into the printer.
10
Slide the latches out, and then pull up to
refasten them.
11
Close the doors.
Clearing image transfer unit jams
1
Open the front access door and the left access
door.
2
While holding down the front access door,
insert a folded piece of paper as shown to clear
the paper sensors under the image transfer
unit. Make sure to clear the entire width of the
paper path.
3
Close the left access door and the front access
door. If the jam persists, continue with step Turn
the printer off. Open the front cover..