Gardena 5041 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kosiarka Gardena 5041. Gardena 5041 17 stron. Battery lawnmower
Również dla Gardena 5041: Instrukcja obsługi (17 strony), Instrukcja obsługi (10 strony)

Drukuj stronę
Gardena 5041 Instrukcja obsługi
To replace the blade:
Troubleshooting table:
Problem
Engine does not start
Engine is jammed and
makes a noise
Loud noises, the mower
is rattling
Product runs unevenly or
vibrates strongly
Lawn is not cleanly cut
ß
Error-LED
on the battery
W
is flashing
ß
Error-LED
on the battery lit
W
ß
Error-LED
on the panel lit
W2
Charging control lamp
does not light up
WARNING! Risk of physical injury!
Cut injury when the blade turns and it is damaged,
bent, out of balance or has chipped edges.
v Do not use the product when the blade is damaged, bent,
out of balance or has chipped edges.
v Do not regrind the blade.
The GARDENA spare parts are availible from your GARDENA dealer
or from the GARDENA service.
Only use an original GARDENA blade:
• GARDENA replacement blade Art. 4104.
1. Let the blade replace by the GARDENA Service or a specialist
dealer authorised by GARDENA .
Possible Cause
Blade is blocked.
Blade is blocked.
Cutting height is too low.
Screws on engine, its fixing or
on the mower chasing are loose.
Blade is damaged or the blade
mounting is released.
Blade is very dirty.
Blade is blunt or damaged.
Cutting height is too low.
Over voltage.
Under voltage.
Battery temperature is out of
range.
Battery error / battery defective.
Blade is blocked.
Motor overload / Controller
temperature is out of range.
t
Battery charger or charging cable
are not connected correctly.
Remedy
v Remove the obstacle.
v Remove the obstacle.
v Raise the cutting height.
v Have screws tightened by
an authorised specialist dealer
or the GARDENA Service.
v Have blade tightened or
replaced by an authorised
specialist dealer or the
GARDENA Service.
v Clean the mower (see 4. MAIN-
TENANCE). If this does not
rectify the problem, contact the
GARDENA Service.
v Have blade replaced by the
GARDENA Service.
v Raise the cutting height.
v Remove the battery and
check that the mains voltage
is correct.
v Charge the battery.
v Use the battery in surroundings
where temperatures are
between – 10 °C and 40 °C.
v Contact the GARDENA service.
v Remove the obstacle.
v Let the controller cool down.
v Connect the battery charger
and charging cable correctly.
23