Gardena 1490 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa wodna Gardena 1490. Gardena 1490 7 stron. Drill pump
Również dla Gardena 1490: Instrukcja obsługi (7 strony)
Drukuj stronę
Connect suction and pressure hoses (using
GARDENA hose fittings). The direction of flow
is shown by the white arrows on the pump top.
Check that the drill rotates clockwise, correspond-
ing with the direction shown by the arrows on the
pump side.
The suction hose should not be more than 3 m
(9 ft.) long. Please make certain that it is leak proof
when connected. The hose should be of non-
collapsing type (hose with woven reinforcement,
e.g. GARDENA Flex Hose or Cord Hose).
Place the suction hose inlet into fluid to be pumped.
Prime pump at max. drill speed. The outlet side
should be open during priming. Pump output can
be regulated by drill speed.
The pump is self-priming. If it does not start
pumping within 12 seconds, switch off at once
and locate the cause (probably a leaking, blocked or
collapsed inlet hose). The pump should not operate
against a closed outlet side for too long a period.
When liquid no longer flows switch off the
electric drill immediately.
After use, or after pumping of fuel oil, clean the
pump out thoroughly with clean water.
4. Technical data
Max. performance
with 13 mm (½" ) hose
with 19 mm (¾" ) hose
(8.81g.p.m.)
Max. pressure
Max. pumping height
Max.suction height
Max. permissible r.p.m.
Max. permissible temperature
of the liquid to be pumped
Drive shaft
Max. dry running time
6
3
1.7 m
/ h
(6.24g.p.m.)
3
2.4 m
/ h
approx. 3 bar
(42 p.s.i.)
approx. 30 m
(98.43 ft.)
approx. 3 m (9ft.)
3,400 r.p.m.
40 °C
∅ 8 mm
12 seconds