KitchenAid KEBDS 90020 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Okap wentylacyjny KitchenAid KEBDS 90020. KitchenAid KEBDS 90020 16 stron.
Drukuj stronę
Installation
After unpacking the appliance, check for any
damage caused during transport. In case of
problems, contact the dealer or the After-Sales
Service. To avoid any damage, it is advisable to only
remove the appliance from the polystyrene base
just before installation.
PREPARATION FOR INSTALLATION
WARNING:
this appliance is heavy; the hood should only
be lifted and installed by two or more people.
The minimum distance between the cooking pan
support on top of the cooker and the bottom of
the hood must not be less than 50 cm for electric
cookers and 65 cm for gas or mixed cookers.
Before installation also check the minimum
distances stated in the manual of the cooker.
If the installation instructions for the cooker specify
a greater distance between cooker and hood, this
distance must be observed.
ELECTRICAL CONNECTIONS
Make sure the power voltage specified on the
appliance rating plate is the same as the mains
voltage.
Safeguarding the environment
Disposal of packing
The packing material is 100% recyclable and is
marked with the recycle symbol
parts of the packing must be disposed of responsibly
and in full compliance with local authority
regulations governing waste disposal.
Disposal of the appliance
- This appliance is marked in compliance with
European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
This information may be found on the inside of the
hood, under the grease filter.
Power cable replacement (type H05 VV-F 3 x 0.75
mm²) must be carried out by a qualified electrician.
Contact an authorized service centre.
If the hood is fitted with an electric plug, connect
the plug to a socket complying with current
regulations, located in an accessible place. If no
plug is fitted
(direct wiring to the mains), or if the socket is not
located in an accessible place, install a standardized
double pole power switch that will enable
complete
isolation from the mains in case of category III
overvoltage conditions, in accordance with wiring
rules.
GENERAL RECOMMENDATIONS
Before use
Remove cardboard protection pieces, transparent
film and adhesive labels from accessories.
Make sure the appliance has not been damaged
during transport.
During use
Do not place weights on the appliance, as they
could damage it.
Do not expose the appliance to atmospheric
agents.
- By ensuring that this appliance is disposed of
. The various
- The
6
correctly, you can help prevent potentially
damaging consequences for the environment and
health.
symbol on the product or on the
accompanying documentation indicates that it
should not be treated as domestic waste but
must be taken to an appropriate collection
centre for the recycling of electrical and
electronic equipment.