KitchenAid KICU265HBT1 Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny KitchenAid KICU265HBT1. KitchenAid KICU265HBT1 13 stron. 36", 48" island canopy range hood
Również dla KitchenAid KICU265HBT1: Instrukcja obsługi (4 strony)
Drukuj stronę
Maintenance
Replacing the light bulb:
This range hood uses fluorescent lamp type F33-15W-T8 and starter type 52.
Remove the retainer clips from both ends of the light cover. Carefully slide the
cover all the way to the right. Then lower the left end of the glass below the
support flange and remove the glass by sliding it back from the left.
Install a new fluorescent light bulb.
Position the right end of the light cover over the flange and slide the cover all the
way to the right. Position the left end of the light cover over the flange and slide
the cover back to left. Reinstall the retainer clips.
retainer
clips
support
flange
F
I
BLKI-- _I-- --
LINE
IN
t2@
URC
_1
6@Hz
Note: If a remote blower is used with this range hood,
current draw must not exceed 4 amps.
Note: Instructions are included with
each kit.
Utensil Bar:
Part No. 4378619 - 15" (38 cm)
long (stainless steel only).
Charcoal Filters:
Part No. 4378623 (2 per pkg.)
Non-Vented (Recirculating} Kits*:
Part No. 4378625 (stainless steel)
Part No. 8171292 (biscuit)
Part No. 4378626 (white)
*These instructionsmust be read
before starting the canopy hood
installation.