Gardena EasyCut Li-18/23 R Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Trymer Gardena EasyCut Li-18/23 R. Gardena EasyCut Li-18/23 R 17 stron. Accu turbotrimmer
Również dla Gardena EasyCut Li-18/23 R: Instrukcja obsługi (16 strony), Instrukcja obsługi (18 strony), Instrukcja obsługi (11 strony), Instrukcja obsługi (17 strony)
Cleaning the trimmer:
s
Replacing the filament
cassette:
W
Y
8. Troubleshooting
Risk of injury!
Pulling the cutting filament
manually out of the filament
cassette:
z
37
20
The ventilation slots must always be free of dirt.
v Clean all moving parts after each use, and especially remove
s
any grass and dirt from the cover
q
Risk of injury!
v N ever use metallic cutting elements or replacement
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
• Filament Cassette for GARDENA Turbotrimmer
1. Remove the battery.
e
2. Release the cassette cover
W
and remove the cover.
3. Remove the filament cassette
4. Remove any dirt.
5. Feed the cutting filament
through the hole
X
6. Insert the filament cassette
Do not trap the cutting filament
7. Fit the cassette cover
click into place.
U
v If the cassette cover
filament cassette
is completely in the filament cassette holder.
Risk of injury from the cutting filament!
v R emove the battery immediately in the event of faults!
A cutting filament that is too short or no longer extends
automatically when the trimmer is turned on can be pulled out
manually.
1. Remove the battery.
2. Hold the automatic slide feed
at the same time pull on the cutting filament
U
parts and accessories not provided by GARDENA.
by pressing both locking clips
e
Y
of the new filament cassette
U
and pull out about 10 cm.
X
.
Y
so that you hear both locking clips
e
cannot be touched down, turn the
e
to and fro, until the filament cassette
Y
ß
37
and ventilation slots
q
.
when you do this.
U
down with your hand and
.
U
.
s
Art. 5306
W
Y
W
Y