Gardena SmallCut 300/23 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Trymer Gardena SmallCut 300/23. Gardena SmallCut 300/23 15 stron. Turbotrimmer
Również dla Gardena SmallCut 300/23: Instrukcja obsługi (9 strony), Instrukcja obsługi (6 strony)

Gardena SmallCut 300/23 Instrukcja obsługi
To clean the trimmer:
w
4
To replace the filament
cassette:
e
r
r
t
t
z
DANGER! Electric shock!
Risk of injury and risk of damage to the unit.
v Do not clean the unit with water or with a water jet
(in particular high-pressure water jet).
The airflow slots must always be clean.
1. Clean the airflow slots
(do not use a screwdriver).
2. Clean all movable parts after each operation. Especially remove
any grass and dirt from the cover
DANGER! Risk of physical injury!
Risk of injury from metal cutting parts!
v D o not use metal cutting parts or replacement parts and
accessories not approved by GARDENA.
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
For Art. 9805 SmallCut 300/23 / Art. 9806 SmallCut Plus 350/23:
GARDENA Filament Cassette for Turbotrimmers Art. 5307
1. Push in cassette cover
time and remove.
2. Remove the filament cassette
3. Remove all dirt.
4. Pull approximately 15 cm of the cutting filament
filament cassette
5. First put the cutting filament
6. Put the cutting filament
7. Put the filament cassette
8. Attach the cassette cover
until you hear both locking clips
i
5
When attaching the cassette cover
u
be put around the guide pin
v I f the cassette cover
cassette
the filament cassette holder
o
with a soft brush
w
on the two locking clips
e
.
t
through the hole in the plastic ring
t
through the metal sleeve
5
around the guide pin
5
into the filament cassette holder
t
on the filament cassette holder
e
r
and must not be caught.
i
cannot be fully installed, turn the filament
e
back and forth, until the filament cassette
t
.
o
.
4
at the same
r
out of the new
5
z
u
.
i
make a click.
, the cutting filament
e
is fully in
t
.
.
.
o
o
must
5
7