Avaya 3606 Podręcznik użytkownika - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Telefon Avaya 3606. Avaya 3606 16 stron.
Również dla Avaya 3606: Skrócona instrukcja obsługi (1 strony), Podręcznik użytkownika (16 strony)

Avaya 3606 Wireless IP Telephone User's Guide

Indications of Low Battery

The wireless telephone will notify you when the charge on the Battery Pack

becomes low. If the wireless telephone is in use, the BATT message will display

and you will hear a soft beep through the earpiece every six seconds. You have

approximately two minutes to complete the call.

If the wireless telephone is idle, you will hear a brief modulated ring signal and the

Low Battery message will display. Your wireless telephone will not operate until

you replace the Battery Pack.

Depending on the charging equipment you have purchased, you will either place

the wireless telephone in a Charging Stand to charge the Battery Pack, or you will

remove the Pack from the wireless telephone and install it in the charger.

Removing and Replacing the Battery Pack on the

Wireless IP Telephone

To remove the Battery Pack, press down on the oval button above the Battery

Pack on the back of the telephone. Slide the Pack toward the bottom of the

wireless telephone until it stops, then lift up.

To replace the Battery Pack, first properly align the top of the Battery Pack with

the arrows on the label on the back of the wireless telephone. Gently press and

slide the Pack toward the top of the wireless telephone until it snaps into place.

You should not have to force it against the wireless telephone.

The Battery Pack may be changed while the call is still in progress by Parking a

call prior to removing the Battery Pack during an active call. The call should then

be retrieved after the Battery Pack is replaced to rejoin the conversation. Check

with the switch administrator for instruction on how to perform this or a similar

process on your particular telephone system.

NOTE: The Park function may conflict with the deskphone per Call Handling.

Take care not to short the Battery contacts on the Pack with metal objects such as

coins, keys or paper clips. Shorting the contacts can cause permanent damage.

Chargers are shipped with the appropriate power supply for the site's location.

Connect the Stand or Charger to an appropriate wall outlet via its power supply

and it's ready for use. Chargers operate in a 50 degrees to 85 degrees F (10

degrees to 30 degrees C) environment. Do not expose them to freezing

temperatures or direct sunlight.

Issue 2 February 2003