Makita XST01Z Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita XST01Z. Makita XST01Z 10 stron. Cordless oil-pulse driver

Drukuj stronę
Makita XST01Z Instrukcja obsługi
NOTE:
To confirm the lamp status, pull the trigger. When
•
the lamp lights up by pulling the switch trigger, the
lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
While pulling the switch trigger, the lamp status
•
cannot be changed.
For approximately 10 seconds after releasing the
•
switch trigger, the lamp status can be changed.
Reversing switch action
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
1
A
1
015152
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
Characteristics of Cordless Oil-impulse
Driver
The
Makita
Cordless
hydraulically operated impact tool using oil viscosity to
produce impacts. Since oil viscosity changes with the
temperature, be aware of the following two points when
operating the tool.
1.
Avoid using the tool below -10 ºC (14 ºF) of
temperature. When the tool temperature goes
down below the degrees, this may cause damage
to the motor of tool due to poor impulse.
2.
When the tool becomes too hot, it may take
longer to set screws.
3.
The tool can overheat, causing a failure or hand
burn if you operate it continuously for long hours.
Let the tool cool off for more than 30 minutes
before
changing
continuous job.
1. Reversing
switch lever
B
Oil-impulse
Driver
batteries
during
a
Changing the impact force
2
3
4
5
1. Changed in four steps
2. Hard
3. Medium
4. Soft
5. T mode
6. Button
012609
is
a
long,
6
1
6