Makita XWT09 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita XWT09. Makita XWT09 12 stron.
Również dla Makita XWT09: Instrukcja obsługi (12 strony)

Drukuj stronę

Indicator lamps

Lighted

Off

NOTE: Depending on the conditions of use and the

ambient temperature, the indication may differ slightly

from the actual capacity.

Switch action

► 1. Switch trigger

CAUTION:

Before installing the battery car-

tridge into the tool, always check to see that the

switch trigger actuates properly and returns to

the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool

speed is increased by increasing pressure on the switch

trigger. Release the switch trigger to stop.

NOTE: The tool automatically stops if you keep pull-

ing the switch trigger for about 6 minutes.

Electric brake

This tool is equipped with an electric brake. If the tool

consistently fails to quickly stop after the switch trigger

is released, have the tool serviced at a Makita service

center.

Remaining

capacity

Blinking

75% to 100%

50% to 75%

25% to 50%

0% to 25%

Charge the

battery.

The battery

may have

malfunctioned.

Lighting up the front lamp

CAUTION:

Do not look in the light or see the

source of light directly.

► 1. Lamp

► 1. Button

To turn on the lamp status, press the button

one second. To turn off the lamp status, press the but-

ton

for one second again.

With the lamp status ON, pull the switch trigger to turn

on the lamp. To turn off, release it. The lamp goes out

approximately 10 seconds after releasing the switch

trigger.

With the lamp status OFF, the lamp does not turn on

even if pulling the trigger.

NOTE: To confirm the lamp status, pull the trigger.

When the lamp lights up by pulling the switch trigger,

the lamp status is ON. When the lamp does not come

on, the lamp status is OFF.

NOTE: When the tool is overheated, the light flashes

for one minute, and then the LED display goes off. In

this case, cool down the tool before operating again.

NOTE: Use a dry cloth to wipe the dirt off the lens of

the lamp. Be careful not to scratch the lens of lamp, or

it may lower the illumination.

NOTE: While pulling the switch trigger, the lamp

status cannot be changed.

NOTE: For approximately 10 seconds after releasing

the switch trigger, the lamp status can be changed.

6 ENGLISH

for