Makita 6010SD Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wiertarka Makita 6010SD. Makita 6010SD 14 stron. 10 mm (3/8")
Drukuj stronęHOW TO USE
Charging
Connect the charging plug t o the charg-
ing connector, then plug in the charger t o
the power receptacle. Charging takes 3
hours.
CAUTION:
The battery
in
your new tool
is
not fully
charged. You will need to charge it be-
fore
use.
Do
not operate the tool during charging.
Overcharging more than 2 days consid-
erably shortens the battery service life.
Always unplug the charger after completing the charge.
When you charge a new tool or a tool which has not been used for a long period, it
may not accept a full charge. This
is
a normal condition and does not indicate a
problem. You can recharge the tool fully after discharging it almost completely a
couple of times.
Installing and removing bit
To install the drill bit, place it
in
the chuck
as
far
as it will go. Tighten the chuck collar
by hand. Place the cuck key
in
each
of
three holes, and tighten clockwise.
To
remove the drill bit, place the chuck
key into the chuck hole and
turn
counter-
clockwise.
CAUTION
:
Always set the Forward-Reverse switch lever t o NEUTRAL when installing, removing or
adjusting bits of accessories.
6