Makita 6092DW Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wiertarka Makita 6092DW. Makita 6092DW 17 stron. 10 mm (3/8") cordless driver drill equipped with electric brake
Drukuj stronęInstalling or removing battery cartridge
0
Always switch off t h e
tool before insertion or removal of the battery cartridge.
*To remove the battery cartridge, pull out
I
0
t h e
set plate on t h e tool and grasp both
sides of the cartridge while withdrawing it
from t h e barrel.
1
To
insert the battery cartridge, align the
tongue on t h e battery cartridge with the
groove in the housing and slip it into
place. Snap the
set plate back into place.
Be sure to close the set plate fully before
using the
tool.
0
Do not use force when inserting the battery cartridge.
If t h e cartridge does not slide in easily, it is not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals on t h e bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert t h e cartridge fully into the port so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If
the charging light does not come on,
press t h e reset button (yellow) first, then
the start button (red). If t h e charging light
goes out within
10
seconds even after pressing the reset button and start button a couple
of times, t h e battery cartridge is dead. (CAUTION: Wait for more than
5 seconds after
the charging light goes o u t
to
press the reset button again.) Replace it with a new one.
When the charging light goes o u t after about one hour, you may remove t h e fully charged
battery cartridge.
After charging, unplug the charger from the power source.
CAUTION :
0
Your new battery cartridge is not charged. You will need
to
charge it before use.
.Do not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also, a malfunction of the charger may result possibly causing overheating,
etc.
0
If you try
to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge
cool off for a while. Then re-insert
it
and try to charge it once more.
6