Makita 6095D Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wiertarka Makita 6095D. Makita 6095D 15 stron. Cordless driver drill
Również dla Makita 6095D: Instrukcja obsługi (14 strony), Lista części (3 strony)
Drukuj stronę
If
you
wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing or removing driver bit or drill bit
CAUTION :
Always
be sure that
the tool
is
switched
off
and the battery cartridge
is
removed before
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn
the
sleeve
counterclockwise.
Storage of driver bit
When not using the driver bit, keep
it
in the storage cavity on the tool.
Switch action
Tool speed is increased by increasing pres-
sure on the trigger. To start the tool,
simply pull the trigger. Release the trigger
to stop.
CAUTION :
Before inserting the battery cartridge into the tool, always check to
see
that the trigger
switch actuates properly and returns to the "OFF" position when released.
7