Ceyear 4024E Podręcznik konserwacji - Strona 16

Przeglądaj online lub pobierz pdf Podręcznik konserwacji dla Przyrządy pomiarowe Ceyear 4024E. Ceyear 4024E 19 stron. Spectrum analyzer

Set the path, click "Set Path", and select the path of the DAC and temperature compensation file,

and then the follow-up measurement DAC file, 4024 test file as well as the compensation file will be

placed into a folder with the name of the spectrometer serial number.

Check 4024 series spectrum analyzer to ensure that there are no IF DAC files and compensation

files. If a DAC or compensation file exists, it shall be deleted firstly. The specific operation is as

follows: Connect the PC with the 4024 spectrum analyzer with a point-to-point network cable, open

the 4024 host folder: "ftp://172.141.xx.xx/" in PC browser, delete tc.tcdoc and IFGainAtten.dc in the

MMCMemory folder, and then restart the spectrum analyzer.

Attention: The IP address of the 4024 spectrometer and PC shall be located on the same network

segment. If they are different, the IP of the computer or spectrometer shall be set to make it within the

same network segment (for example, if the IP of the spectrometer is 172.141.11.202, the IP of the

computer shall be set to 172.141.11.xx).

Connect the computer with the spectrum analyzer with a point-to-point network cable; connect the BNC

cable with 10 MHz reference input of the spectrometer and 10 MHz reference output of the signal

source, and then connect the cable connected with the power meter sensor in steps c) and d) with the

RF input port of the spectrometer, as shown in the above figure. Click Calibration Spetrum, and when the

calibration is completed, it will prompt that the "IFGainAtten.dc" file will be generated. This file is in the

folder with the name of the serial number created in step e).

Keep the connection mode in step 7 unchanged and click the Measure Spetrum, and the

compensation program will carry out 4024 preamplifier OFF and preamplifier OFF data test, the

screen will prompt the current measurement tasks, and it will prompt to generate the "tc.tcdoc" file

Fig. 13 Finish of Calibration Signal Source

GPIB card

10MHz out

Signal source

Network cable

Fig. 14 Measure Spectrum Analyzer

BNC cable

Adapter

2.4 mm cable

Adapter

Spectrum analyzer

10MHz in