HIKVISION Door Station Skrócona instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla System interkomu HIKVISION Door Station. HIKVISION Door Station 17 stron.
Drukuj stronę
Safety Instruction
Warning
The working temperature of the device is from -10 ºC to 55 ºC.
•
All the electronic operation should be strictly compliance with the electrical
•
safety regulations, fire prevention regulations and other related regulations in
your local region.
Please use the power adapter, which is provided by normal company. The power
•
consumption cannot be less than the required value.
Do not connect several devices to one power adapter as adapter overload may
•
cause over-heat or fire hazard.
Please make sure that the power has been disconnected before you wire, install
•
or dismantle the device.
When the product is installed on wall or ceiling, the device shall be firmly fixed.
•
If smoke, odors or noise rise from the device, turn off the power at once and
•
unplug the power cable, and then please contact the service center.
If the product does not work properly, please contact your dealer or the nearest
•
service center. Never attempt to disassemble the device yourself. (We shall not
assume any responsibility for problems caused by unauthorized repair or
maintenance.)
Caution
Do not drop the device or subject it to physical shock, and do not expose it to
•
high electromagnetism radiation. Avoid the equipment installation on vibrations
surface or places subject to shock (ignorance can cause equipment damage).
Do not place the device in extremely hot (refer to the specification of the device
•
for the detailed operating temperature), cold, dusty or damp locations, and do
not expose it to high electromagnetic radiation.
The device cover for indoor use shall be kept from rain and moisture.
•
Exposing the equipment to direct sun light, low ventilation or heat source such
•
as heater or radiator is forbidden (ignorance can cause fire danger).
Do not aim the device at the sun or extra bright places. A blooming or smear
•
may occur otherwise (which is not a malfunction however), and affecting the
endurance of sensor at the same time.
Door Station Quick Start Guide
vi