Alien Aircraft Super Dragon AG-501 Podręcznik - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik dla Zabawka Alien Aircraft Super Dragon AG-501. Alien Aircraft Super Dragon AG-501 7 stron. Glow conversion
Drukuj stronę16...Test fit the motor mount & motor onto the pylon. Remove
them. Use clear polyurethane or dope to fuel proof the front of
the firewall. You do not need to use enough to get a nice finish
on the wood. A thin application allowed to soak into the wood
will be fine.
17...Make the throttle servo mount by gluing the two GP-8's to
the ends of GP-07. Glue two pieces of 1/4" sq. spruce to the
insides of the GP-08's as shown. Now mount the throttle servo
onto the mount. Mount the servo up so that there is at least a
1/8" gap between the servo and GP-07.
18...Mount the radio switch in the cutout in the front of the
servo tray. Use a wire extension from a hole in the switch to the
outside of the fuselage. Glue a piece of scrap balsa in front of
the wire to trap it in the switch.
Now continue with the covering instructions in the main assembly manual.
Follow the remainder of the final assembly steps in the main manual with the following exceptions:
Step 142...You do not need to mount the arming switch.
Step 144...You do not need to mount the electronic speed control.
Steps 145 -148...Not applicable.
Step 149...Do this step.
Step 150...Do this step. Use epoxy. You do not have to run the motor wires but you do need to glue the pushrod
housing to the top & bottom of the wing. When the glue is dry, trim the pushrod housing flush with the bottom of
the wing.
151-154...Not applicable.
...Mount the motor & mount to the firewall.
...Glue the throttle servo mount to the bottom of the wing. Remove the covering from the wing at the location of the
servo mount.
...Install the throttle pushrod. Use a nylon clevis to connect the pushrod to the motor. Use an EZ Connector to
connect the pushrod to the servo.
...Install propeller.
Steps 155-161...Do these steps.
Step 162...Not applicable.
Steps 163-end...Do these steps.
Page 7