Alien Flier EZ-Up Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sport i rekreacja Alien Flier EZ-Up. Alien Flier EZ-Up 3 stron. Zip line

Drukuj stronę

Step 1.

DO NOT START YOUR LINE HIGHER

THAN 12 oﬀ of the ground. The ideal

site for your zip line is a clear span over

level ground. Using a ladder, tack the

op onal wooden blocks to the upper

tree with nails at the desired height. If

you don't have wooden blocks you may

gently tack nails into the tree's bark only.

This will help hold the cable in place

during installa on. Nails may be

removed a er installa on is complete.

Step 5.

Grab the end with the black webbing

loop in one hand. Thread the black

webbing strap through the black

webbing loop.

EZ-Up Zip Line Installa on Guide

Tools Needed: 7/16" wrench

Mount your zip line to healthy, live trees that are at least 12" in diameter and ﬁrmly rooted in the ground!

Step 2.

U n r o l l t h e

cable between

the trees on

t h e g ro u n d .

Wrap the cable

a r o u n d t h e

upper tree as

shown, so it is

res ng on the nails. Pull the cable ght

and go to the other end of the zip line.

Step 6.

Insert the ﬂat end of the black sling in to

the slot/barrel of the black ratchet

Step 3.

Go to lower tree. Thread black webbing

sling and red safety sling though the

pieces of mesh sleeves. Ratchet and

loop must be on the same side. Use as

many sleeves as needed to protect your

tree and the webbing. You may need to

stretch the mesh.

Step 7.

Reel in approximately 6" of the black

webbing by ratche ng the handle -

approximately 1 ½ turns.

Step 4.

Place the assembly from Step 3 around

the lower tree as shown.

Step 8.

Pull the cable ght to determine where

the lower eye on the cable needs to go. It

should be about 2

. from the large

hook on the lower tree. This is necessary

to compensate for slack in the line.