Align-Pilates M8-Pro Reformer Instrukcja montażu i instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja montażu i instrukcja obsługi dla Trenażer eliptyczny Align-Pilates M8-Pro Reformer. Align-Pilates M8-Pro Reformer 12 stron.

Drukuj stronę

Next, thread the end of the rope through the silent pulley from above and then slide the end through the T-Bar rope

adjuster, under the carriage, you will need to pull down the locking handle to allow the rope end [to pass through

(Fig.23).

3. Setting up the rope length

a. First, put the spring bar as close to the foot bar as possible (attach at least one spring before moving).

b. Now put the T-Bar in the position where the most of the chrome bar is revealed (this is the position where the

ropes are longest) and put the larger foot handle over the shoulder rest as shown. (Fig.24).

c. Next, pull the ropes through from underneath until they are both tight. When done tie a knot about six inches

from the end of the rope (Fig.25) - the rope ends can be tidied away by wrapping them around the T bar.

4. Adjusting the side wheels

After attaching at least one spring, roll the carriage back and forward checking that the carriage runs freely for the

whole length of the runner. There should be no squeaking or interference from the side wheels, if there is the side

wheels need to be moved inwards. Conversely there should not be excessive

side to side movement of the carriage in the runners or the wheels need to

be moved out.

To move the side wheels in (ie because they are causing the carriage to jam

or, causing squeaking noises) unscrew bolt B a few turns (Fig. 26) then loosen

the two A bolts and push the wheel bracket in until it hits the stop screw B, then

retighten bolts A - now try the carriage again. If there is too much side to side

movement of the carriage, then the side wheels need to be moved out. To

do this loosen bolts A, then tighten bolt B by a few turns, which will push the

wheel out, then retighten bolts A and try the carriage again. We recommend

small adjustments each time and after a few tries you should get the carriage

to run perfectly, with no interference from the side wheels & little side to side

movement possible.

5. Attaching and adjusting the foot strap

a. The foot strap attaches the same way the ropes attach to the handles. First separate the foot strap in to 2 parts

b. Take each part of the foot strap and thread the loop through the eyelet beneath the spring bar, then thread the

strap through the loop (Fig.27/28/29).

c. When both sides are attached thread the end of the strap though the D rings (Fig.30).

d. The strap can be shortened by pulling on the end of the strap, to loosen release the pressure by opening the D

rings and then lengthening the strap.

Your M8-Pro Pilates reformer is now set-up and ready to use. Please read the User Guide information on pages 8-12

prior to first use.

Fig.24

Fig.23

Fig.25

Fig.26