A'OK AC-135 Podręcznik użytkownika
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Pilot zdalnego sterowania A'OK AC-135. A'OK AC-135 3 stron.
1. Link the Shade to the Remote Control
2. Set Upper position for the shade
a. Bend a paperclip to
PRESS/HOLD the inset
button on the BACK of
the control, until the
shade rotates briefly
up and down
3. Set Lower positions for the shade
a. PRESS/HOLD the
DOWN button 3
seconds to start the
shade down. Press
STOP when the shade
is near the desired
lower position.
Notes: If action between steps (a, b, c) takes longer than 30 seconds, the program will not complete. Simply start each step again at sub-step 'a.'
Up to 4 intermediate stops can be set by following Step 3 for each. IF the shade does not follow commands, DELETE all Memory (next page) and start over.
FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
AC-135 User Manual
(if you are adding multiple shades to a controller, see instructions at bottom of Page 2)
a. Select the Channel
(for Multi-Shade remotes)
Press the
RIGHT/LEFT
buttons to select
desired channel
(start on 1, then can
.
add others)
Select a single
channel, not ALL
(ALL=all lights on)
(wait 30 seconds if just completed Step 1)
b. Press the UP
and/or DOWN
buttons until
the shade is at
the desired top
position.
(wait 30 seconds if just completed Step 2)
b. Use a paperclip
to PRESS/HOLD the
button on the BACK
of the remote, until
the shade rotates
briefly up and
down
(page 1)
b. Press/hold the Program button
With a paper
clip or small
screwdriver,
PRESS and
HOLD BUTTON
until shade
rotates briefly
up and down
c. Use a paperclip to
PRESS/HOLD the
button on the BACK
of the remote, until
the shade rotates
briefly up and down.
c. Press the UP
and/or DOWN
buttons until the
shade is at the
desired position.
c. Link to Remote
Press the UP
button on the
Remote once.
The shade rotates
briefly up and
down. Test
UP/STOP/DOWN
buttons once
each.
IF shades moves in reverse:
Wait 30 seconds since
last command.
PRESS/HOLD the STOP
button for 5 seconds
until the shade rotates
briefly up and down.
Press the DOWN button
once. The shade rotates
briefly up and down to
signal reversed direction.
d. Use a paperclip to
PRESS/HOLD the
button on the BACK
of the control, until
the shade rotates
briefly up and down