Garmin Zumo 396 Instrukcja obsługi - Strona 27

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla GPS Garmin Zumo 396. Garmin Zumo 396 32 stron.
Również dla Garmin Zumo 396: Instrukcja instalacji (46 strony), Instrukcja obsługi (32 strony)

Drukuj stronę

Device Care

Avoid dropping your device.

Do not store the device where prolonged exposure to extreme

temperatures can occur, because it can cause permanent

damage.

Never use a hard or sharp object to operate the touchscreen, or

damage may result.

Cleaning the Outer Casing

Avoid chemical cleaners and solvents that can damage plastic

components.

Clean the outer casing of the device (not the touchscreen)

using a cloth dampened with a mild detergent solution.

Wipe the device dry.

Cleaning the Touchscreen

Use a soft, clean, lint-free cloth.

If necessary, lightly dampen the cloth with water.

If using a dampened cloth, turn off the device and disconnect

the device from power.

Gently wipe the screen with the cloth.

Avoiding Theft

• Remove the device and mount from sight when not in use.

• Remove the residue left on the windshield by the suction cup.

• Do not keep your unit in the glove compartment.

• Register your device using the Garmin Express software

(garmin.com/express).

Resetting the Device

You can reset your device if it stops functioning.

Hold the power key for 12 seconds.

Removing the Device, Mount, and Suction

Cup

Removing the Device from the Mount

Press the release tab or button on the mount.

Tilt the bottom of the device upward, and lift the device from

the mount.

Removing the Mount from the Suction Cup

Turn the device mount to the right or left.

Apply pressure until the socket on the mount releases the

ball on the suction cup.

Removing the Suction Cup from the Windshield

Flip the lever on the suction cup toward you.

Pull the tab on the suction cup toward you.

Changing the Fuse in the Vehicle Power

Cable

When replacing the fuse, do not lose any of the small pieces

and make sure they are put back in the proper position. The

vehicle power cable does not work unless it is assembled

correctly.

If your device does not charge in your vehicle, you may need to

replace the fuse located at the tip of the vehicle adapter.

Rotate the end piece

Troubleshooting

NOTICE

counter clockwise to unlock it.

TIP: You may need to use a coin to remove the end piece.

Remove the end piece, the silver tip

Insert a new fast-blow fuse that has the same current, such

as 1 A or 2 A.

Place the silver tip in the end piece.

Push in the end piece and rotate it clockwise to lock it back

into the vehicle power cable

Troubleshooting

The suction cup will not stay on my

windshield

Clean the suction cup and windshield with rubbing alcohol.

Dry with a clean, dry cloth.

Mount the suction cup

(Mounting Your Device in an

Automobile, page

2).

My device is not acquiring satellite signals

• Verify the GPS simulator is turned off

page

20).

• Take your device out of parking garages and away from tall

buildings and trees.

• Remain stationary for several minutes.

The device does not charge in my vehicle

• Check the fuse in the vehicle power cable

Fuse in the Vehicle Power Cable, page

• Verify the vehicle is turned on and is supplying power to the

power outlet.

• Verify the interior temperature of the vehicle is within the

charging temperature range indicated in the specifications.

• Verify the fuse is not broken in the vehicle power outlet.

My battery does not stay charged for very

long

• Decrease the screen brightness

• Shorten the display timeout

• Decrease the volume

(Adjusting the Volume, page

• Turn off the wi-fi radio when it is not in use

page

20).

• Put the device in power saving mode when not in use

(Turning the Device On or Off, page

• Keep your device away from extreme temperatures.

• Do not leave your device in direct sunlight.

My device does not connect to my phone or

Smartphone Link

• Select Settings > Bluetooth.

The Bluetooth option must be enabled.

• Enable Bluetooth wireless technology on your phone and

bring your phone within 10 m (33 ft.) of the device.

• On your smartphone, open the Smartphone Link app, and

select

to restart the Smartphone Link background

services.

• Verify your phone is compatible.

, and the fuse

(Navigation Settings,

(Changing the

23).

(Display Settings, page

20).

3).

‑ Fi

(Wi

Settings,

3).

20).