Garmin zumo 660LM Instrukcje instalacji
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla GPS Garmin zumo 660LM. Garmin zumo 660LM 4 stron. For bikers
Również dla Garmin zumo 660LM: Skrócona instrukcja obsługi (8 strony), Przegląd (4 strony)
Drukuj stronę
zūmo 660 Installation Instructions
Mount Your zūmo on the Motorcyle
Warning: Incorrectly wiring the power cable with bare wire leads can result in
damage to the vehicle or the battery and can cause bodily injury. Garmin strongly
recommends having an experienced installer with the proper knowledge of electrical
systems install the unit.
See the Important Safety and Product Information guide in the product box for product warnings
and other important information.
Step 1: Connect Power to the Mount
Select a suitable and secure location to mount the zūmo on your motorcycle, based on
available power sources and safe cable routing.
Cradle
Power cable
Microphone jack (2.5 mm)
Step 2: Install the Handlebar Base
The zūmo includes parts for two handlebar installation solutions. Custom mounts can
require additional hardware (www.ram-mount.com).
A) To install the U-bolt and handlebar base:
1. Place the U-bolt around the handlebar, and thread the ends through the handlebar
base.
2. Tighten the nuts to secure the base. Do not overtighten.
note: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in.
Handlebar
Headphone/audio out jack (3.5 mm)
Bare wires with
inline fuse for
power connection
Mini-USB connector
(for traffic receiever)
Handlebar
base
U-bolt