Garmin Zumo XT Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla GPS Garmin Zumo XT. Garmin Zumo XT 49 stron.
Również dla Garmin Zumo XT: Skrócona instrukcja obsługi (8 strony), Instrukcja instalacji (46 strony)
NOTE: An additional replacement screw is included in the
box.
Attaching the Base Plate to the Motorcycle Mount
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
washers
, cradle, spacers
2
Tighten the nuts to secure the base plate.
Attaching the Base Plate to the Handlebar Base
1
Align the ball of the handlebar base
base plate
with each end of the double-socket arm
2
Insert each ball into the double-socket arm.
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
Installing Your Device in the Motorcycle Mount
1
Fit the bottom of your device into the cradle.
2
Push the top of the device forward until it snaps into place.
The latch
on the mount stays up after you insert the
device.
Removing Your Device from the Motorcycle
Mount
1
Press the release button on the top of the mount.
2
Lift out the device.
Rider Awareness Features and Alerts
NOTICE
through the
, and base plate
.
and the ball of the
Mounting Your Device in an Automobile
Before mounting the device, check the local laws pertaining to
windshield mounting.
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use the suction cup mount on a motorcycle.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
NOTE: The automobile mount is not included with all device
models. Go to
garmin.com
1
Plug the automotive power cable
device.
.
2
Remove the clear plastic from the suction cup
3
Clean and dry your windshield and the suction cup with a lint-
free cloth.
4
Press the suction cup to the windshield, and flip the lever
back toward the windshield.
5
Snap the cradle
6
Fit the bottom of your device into the cradle.
7
Press the device into the cradle until it snaps into place.
8
Plug the other end of the automotive power cable into a
power outlet.
Rider Awareness Features and Alerts
The rider alerts and speed limit features are for information only
and do not replace your responsibility to abide by all posted
speed limit signs and to use safe driving judgment at all times.
Garmin is not responsible for any traffic fines or citations you
receive for failing to follow all applicable traffic laws and signs.
Your device provides features that can help encourage safer
riding, even when you are riding in a familiar area. The device
plays an audible tone or message and displays information for
each alert. You can enable or disable the audible tone or
message for each type of alert. Not all alerts are available in all
areas.
School zone or nearby school: The device plays a tone and
displays the distance to and speed limit (if available) for an
upcoming school or school zone.
Speed limit reduction: The device plays a tone and displays
the upcoming reduced speed limit so you can be prepared to
reduce your speed.
NOTICE
WARNING
to purchase optional accessories.
into the port
onto the suction cup arm.
NOTICE
on the
.
3