Alisun Sun lounge Salsa 12 Podręcznik techniczny - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik techniczny dla Latarnia Alisun Sun lounge Salsa 12. Alisun Sun lounge Salsa 12 14 stron.

ENGLISH

ASSEMBLY

Fasten the gas absorber (A) to the

stand (B) by means of the plastic

washer (C) and the locking spring (D).

NOTE: The locking spring should be

pushed in properly, as far as it will go. Once

fitted, a locking spring should not be

removed. A locking spring can only be used

once.

Grasp the canopy on either side of the

centre, then lift it upwards.

Now tilt the equipment such that its

front surface is on the floor.

Fasten the swivel casters (A) to the

bottom of the stand (B).

Now replace the canopy (C) on the

stand.

Remove the protective plastic from the

acrylic sheet.

Check if the voltage rating of your

facilities corresponds with the rating on

the type label.Then insert the plug of

the power cord into a grounded wall

socket.

Your unit is now ready for use.

USAGE

Wheel the equipment (A) (in a vertical

position), to the foot of the bed or place

it in front of a chair. See to it that the

equipment is always located on a flat

surface.

NOTE: the slots of the wheeled base (B)

(incorporating ballast) must not become

covered by any foreign objects.

Grasp the canopy on either side and

pull it towards you.

OPERATION

You can set the timer to the required

number of minutes by turning it clockwise.

After the time has expired the timer will

switch off automatically. If you want to

switch off your unit sooner, the timer should

be turned anti-clockwise to the zero

position.