4. Find and highlight the incorrect Programmer entry on the Device
Manager list, click on "Remove", then click 'OK' to confi rm.
5. Click "Refresh", then click "Next" to begin searching for the driv-
ers. On the next screen, let Windows search by leaving the bullet
on the "Search for best driver.." option and click "Next". On the
next screen, check ONLY the "CD-ROM drive" option and click
"Next".
6. The Wizard will search for the driver and then display a window
to tell you it is ready to install. Click on "Next". You may see a
"Copying Files..." screen which tells you the fi le cannot be found.
Choose Root Directory of the CD-ROM drive if not already there,
and to try copying again (example d:\). Click "OK" to continue.
7. When installation is complete a window should display that shows
the device name (Garmin USB Data Card Programmer) and states
the driver installation is fi nished. Click on "Finish".
8. To make sure the USB Programmer has been successfully installed:
From the Control Panel, click on "System", then the "Device Man-
ager" tab, then click the + by "Universal serial bus controller".
You should see "Garmin USB Data Card Programmer" on the list.
Another method would be to open the MapSource program, click
the 'Save To Device' icon, then the 'USB Port' tab. You should see
"Card Programmer" listed in the "Save Maps To:" window.
If the installation is still not successful, try shutting the computer
off for 1 minute, then trying the alternate steps again. A red 'X' over
the Programmer icon in Device Manager normally indicates a defec-
tive Programmer. If the USB Programmer still will not install, please
contact Garmin Product Support for further assistance.
Installation
Installing the Device Drivers
Windows XP Users: During installation of the USB
Data Card Programmer you will see a message stating:
"The following device has not passed the Windows Logo
testing to verify its compatibility with Windows XP.
Continuing your installation of this software may
impair or destabilize the correct operation of your
system either immediately or in the future. Microsoft
strongly recommends that you stop this installation now
and contact the hardware vendor for software that has
passed Windows Logo testing."
Garmin engineers have fully tested this prod-
uct and it is compatible with Windows XP.
Press the 'Continue Anyways' button to fi nish
the installation.
3
Drukuj stronę