Brother 884-B03 Instrukcja obsługi - Strona 25

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyna do szycia Brother 884-B03. Brother 884-B03 38 stron. Compact overlock machine

Drukuj stronę

If threads break during sewing

Remove the material and re-thread in the correct

order, Lower looper, Upper looper, right needle and

then the left needle (to re-thread, see CHAPTER

3 "Threading"). Replace the material under the

presser foot and sew 3-5 cm (1-1/8 to 2 inches)

over the previous stitches.

CAUTION

Do not leave straight pins in the fabric when

sewing as they will damage the needles and

knives.

To sew ﬁ ne materials

1. Adjust the presser foot pressure to prevent the

material from puckering and to allow sewing

of curves. (See CHAPTER 1 "Adjusting the

presser foot pressure".)

2. Loosen the thread tension, but remember that if

the tension is too loose, the thread may break

and stitches may be skipped.

Narrow overlock/ Rolled hemming stitch

The Narrow overlock/Rolled hemming stitch is

a decorative ﬁ nish for lightweight to midweight

fabrics. It is often used to complete the edge of

a fabric. This stitch is sewn by removing the left

needle and using the 3-thread overlock stitch.

Instructions for both narrow overlock/

Rolled hemming stitches

CAUTION

Turn off the main power and light switch before

removing/ installing a needle.

1. Remove the left needle.

NOTE:

For the recommended thread and needle, see

CHAPTER 4 "Sewing materials, threads, and

needles comparison chart".

2. Thread the machine for a three thread overlock,

using the right needle.

3. Remove the stitch ﬁ nger <A>.

1 Raise the presser foot lever.

2 Pull all threads toward the back of the

machine.

3 Check to make sure that the thread is no

longer wrapped around the stitch ﬁ nger.

4 Open the front cover.

5 Turn the hand wheel until the upperlooper is

at its lowest position.

6 Pull the stitch ﬁ nger to the right and remove

it.

<A>