Garmin GPS 17HVS - Receiver Module Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Morski system GPS Garmin GPS 17HVS - Receiver Module. Garmin GPS 17HVS - Receiver Module 16 stron. Declaration of conformity
Również dla Garmin GPS 17HVS - Receiver Module: Instrukcja instalacji (12 strony), Specyfikacja techniczna (34 strony), Specyfikacja techniczna (40 strony), Specyfikacja techniczna (37 strony), Deklaracja zgodności (2 strony)

Drukuj stronę
Garmin GPS 17HVS - Receiver Module Instrukcja instalacji
W
GPS 17
IRING THE
W
IRING THE
After mounting the GPS 17 in the desired location, connect
the wiring. Connect the GPS 17's Port 1 Data In, Data Out,
Remote On/Off, and Ground (Return) lines to your NMEA
device or PC. Port 2 is used for RTCM input only.
For reliable communication, it is essential that the GPS
17 and the receiving device share the same ground. This
ground connection acts as the (signal) Return line. Wire
the unit to its own circuit to avoid interference from other
electronics.
You need a DB-9 or DB-25 serial connector (normally
female) if you are connecting the GPS 17 to a PC. Check
with a PC or electronics supplier for these items.
4
9
8
7
6
DB-9 Female
Serial Connector
6
GPS 17
7
25
14
DB-25 Female
Serial Connector
Garmin recommends that you install a 1A fuse on the power
(+) line of the receiving device.

Wire Color Code

Red: Power (+) 8–40 VDC.
Black: Ground (Power (-) and Data Signal Return)
Yellow: Remote power On/Off
Blue: Port 1 NMEA Data Input
White: Port 1 NMEA Data Output
Gray: Pulse Per Second Output
Green: Port 2 RTCM Data Input
Violet: Port 2 RTCM Data Output (Not Used)
GPS 17 Installation Guide