Garmin GPS 400W Dodatek do podręcznika pilota - Strona 19
Przeglądaj online lub pobierz pdf Dodatek do podręcznika pilota dla Morski system GPS Garmin GPS 400W. Garmin GPS 400W 24 stron. Garmin gps receiver quick reference guide
Również dla Garmin GPS 400W: Dodatek do podręcznika pilota (24 strony), Dodatek do podręcznika pilota (50 strony), Skrócona instrukcja obsługi (23 strony), Podręcznik uzupełniający (12 strony), Skrócona instrukcja obsługi (25 strony)
Drukuj stronę
TRFC (White)—Altitude separation >500 feet,
steady altitude separation
TA (Yellow)—Altitude separation 500 feet,
steady altitude separation
TRFC (White)—Altitude separation >500 feet,
closing
PA (White)—Altitude separation 500 feet,
opening
TRFC (White)—Altitude separation >500 feet,
opening
TA (Yellow)—Altitude separation 500 feet,
closing
Configuring TCAD Data on the Map Page
The display of traffic information closely resembles
the display symbology used by the Ryan TCAD. Traf-
fic data is only displayed on the Map Page if head-
ing data is available.
You can configure TCAD data on the Map
Page using the Map Setup Menu.
To configure Traffic on the Map Page:
1.
Turn the small right knob to select the Map
Page.
Press MENU to display the Page Menu.
2.
3.
Use the small right knob to select "Setup
Map?" and press ENT.
4.
The flashing cursor highlights the GROUP field.
Turn the small right knob to display the Map
Setup Options Menu. Turn the small right
knob to select Traffic and press ENT.
Turn the large right knob to select the desired
5.
Traffic Mode option.Turn the small right knob
to select the desired option and press. Repeat
the step for Traffic Symbol and Traffic Label.
Return to the Map Page by pressing CLR.
6.
The Map Page has the ability to display traffic in
a thumbnail format in any of the top three fields (top
four fields on a 500W Series unit) on the right-hand
side of the Map Page.
To display Thumbnail Traffic on the Map
Page:
1.
Turn the small right knob to select the Map
Page.
Press MENU to display the Page Menu.
2.
Use the small right knob to select "Change
3.
Fields?" and press ENT.
4.
Select one of the top three fields (top four
fields on a 500W Series unit). Select TRFC
from the Select Field Type List and press ENT.
Note that the thumbnail range defaults to 6
NM and cannot be changed for TCAD 9900BX
and slaves to the current shield size for TCAD
9900B.
Section 4
Ryan TCAD Interface
17