Garmin GPSMAP 400 series Podręcznik pilota - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik pilota dla Morski system GPS Garmin GPSMAP 400 series. Garmin GPSMAP 400 series 28 stron. Non-waas; display interfaces
Również dla Garmin GPSMAP 400 series: Instrukcja obsługi (6 strony), Dodatek do podręcznika pilota (27 strony), Skrócona instrukcja obsługi (2 strony), Podręcznik referencyjny (2 strony), Instrukcja instalacji (28 strony), Instrukcja instalacji (30 strony), Podręcznik szablonu (2 strony), Szablon (1 strony), Podręcznik konfiguracji (2 strony), Skrócona instrukcja obsługi (2 strony)

Drukuj stronę
Garmin GPSMAP 400 series Podręcznik pilota

Clearing the Map Page

Routinely clearing the Map Page of all discharge points
is a good way to determine if a storm is building or
dissipating. In a building storm discharge points reappear
faster and in larger numbers. In a dissipating storm
discharge points appear slower and in smaller numbers.
Clearing the Map Page of all discharge
points:
1)
From the default Nav Page, turn the small right
knob to select the Map Page.
Press the MENU Key to display the Page
2)
Menu.
3)
Turn the small right knob to select 'Clear Storm
Data?' (Figure 2-4).
Figure 2-4 Map Page Menu
Press the ENT Key.
4)
190-00140-10 Rev. E

Storm Data Display Range

Storm data can be displayed on the 2000 nm zoom
scale, but the data only goes out as far as the STORMSCOPE
can report (200 nm).
North Up Mode: Since the range for Stormscope data
is 400 nm diameter total (200 nm in front and 200 nm
behind), the 500 nm range in North Up mode shows all
the data.
Track Up Mode: In the Track Up mode at the 500
nm range, a portion of Stormscope lightning data can be
behind ("aft" of) the aircraft and therefore not visible on
the Navigation Map.
Selecting a storm data display range:
From the default Nav Page, turn the small right
1)
knob to select the Map Page.
2)
Press the MENU Key to display the Page Menu.
3)
Turn the small right knob to select 'Setup Map?'.
Press the ENT Key.
4)
5)
Turn the small right knob to select the Weather
Group.
Press the ENT Key.
6)
Turn the large right knob to select the desired
7)
lightning symbol option.
8)
Turn the small right knob to select the desired
range (Figure 2-5).
9)
Press the ENT Key.
400/500 Series Display Interfaces
SECTION 2
STORMSCOPE INTERFACE
Figure 2-5 Range Window
2-3