alkitronic CLSD 100 Instrukcja obsługi i konserwacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sprzęt testowy alkitronic CLSD 100. alkitronic CLSD 100 16 stron. Mounting documentation system

Drukuj stronę

2150

29 R

The system will start with a waiting time of five seconds; if

further bolt jobs are pending, the counter is incremented up

(the number of completed and the total number of bolted

joints are displayed on the screen). The next bolting action

can be started.

Set the torque tool to the next bolting point. Before

each subsequent bolting action the <Enter> must

be pressed.

If, however, the predefined maximum number of bolting

actions has been reached, the program will terminate and

switch to the main menu.

End?

Yes

and confirm with the <Enter> key.

5.2.4 Assessment criteria

Depending on the assessments as follow the result is stored:

Status

> max. torque

< min. torque

Between max.

angle < target minus 5°

torque and

angle > target plus 5°

min. torque

angle between target minus 5°

and target plus 5°

MDS

Mounting Documentation Systems

Display: The current torque mea-

sured and the max. angle is dis-

played. The evaluation of the

screwing process is shown as

"OK" or "nOK".

Note:

If during a bolting action the

<Enter> key is pressed there will

be a query screen: End program?

Select with the >cursor (

↓ ) ( ↑ )

Status

Not OK

5.2.5 Documentation data

Wert

Content

Year/Month/Day/hours/minutes

Global counter ID (incremented by each process)

Program

Current torque

Maximum value during the measurement

Minimum torque

As predefined

Maximum torque

As predefined

Pre-torque

As predefined

Target angle

As predefined

Current angle

Maximum value during the measurement

5.3

Bolting program 3

Exclusively for the

HSD model of

MDS product range.

Make the program

selection in the

main menu.

5.3.1 Application description

Program for checking previously tightened torque values.

Bolted joints are tightened with a predefined angle; the target

torque must be pre-defined within the tolerance limits. The ac-

tually applied torque is tested and simultaneously evaluated.

Determination of the breaking torque (counter-clockwise).

5.3.2 Parameter setting

•

Number of boltings

•

Target angle

•

Min. torque

•

Max. torque

5.3.3 Process description

During the tightening process the torque increases conti-

nuously. When the torque reaches the switching threshold

(value see parameter table 4.1) the program continues to show

the current max. torque and will also simultaneously measure

the rotation angle. When the current rotation angle exceeds

the predefined target angle (minus 1° tolerance) the user is

notified by a visual signal from a green LED for two seconds

and a long signal tone. If the measured torque continues to

increase and exceeds the predefined maximum the user is

notified by a continuously interrupted signal tone and a red

light. This warning will switch off when the torque falls below

the maximum or the <Enter> key is pressed.

Once the current torque drops below the switching threshold

the bolting data is stored in memory and evaluated.

The parameters on the left-

must all be entered to ensure

correct data recording and

evaluation..