Garmin TR-1 Gold Skrócona instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Morski system GPS Garmin TR-1 Gold. Garmin TR-1 Gold 2 stron. Throttle actuator
Również dla Garmin TR-1 Gold: Instrukcja obsługi (38 strony), Podstawowa instrukcja obsługi (9 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja montażu (7 strony), Instrukcje instalacji (4 strony)
Drukuj stronę
www.reelschematic.com
www.reelschematic.com
How to use Pattern Steering
Press and Hold the
ton down, press, select and light up the LED number to the correspond-
ing pattern from the table below. Release the Setup button. To engage
pattern steering press and release the corresponding button (Idle/Resume,
or Bent Arrow Buttons, etc).
1
MOB
2
Idle/Resume
3
Other/ Zig-Zags
To read out the value of the
code. Enter the Code on the
handheld (See Steps 1 & 2).
Press and hold the [Select
Load] GPS button, and read
the blinked code on the up and
down arrows. Example: Steps,
default is set at 45 degrees,
so the down arrow will blink
8 times. When you are at the
highest setting the up arrow will
be solid. When you are at the
lowest setting the down arrow
will be solid.
TR-1 Gold Owner's Handheld Quick Reference
Button. While holding the Setup but-
4
Step Turns
7
Orbits
5
Circles
8
Cloverleaf
6
Remote Steer 9
Search
Function
Code To Change
Settings
Degrees Per Step
Circle Time
Zig- Zag Amplitude
Zig-Zag Period
Cloverleaf Length
Search Spacing
Orbits
The Autopilot will orbit the waypoint you have activated in your GPS at the distance from
which you activate and enter the mode on the handheld.
How to Change the Values of the Parameters
3. Increase the value of the parameter one step by each
press of the Up Arrow button.
Decrease the value of the parameter one step by each press
of the Down Arrow button
6
10 Choices/ 1,2,3,4,5,10, 15, 30, 45, or 90 Degrees
7
10 Choices/ 1,2,3,4,5,10, 15, 30, 45, or 90 Minutes
8
10 Choices/ 5 to 50 degrees by 5's
9
20 Choices/ 1 to 20 minutes by 1's
29
500 ft to 1,000 ft by 50 ft increments
249
50 ft to 1,000 ft by 50 ft increments
1. Press and release the Setup Button.
2. Using the codes below, Make selection of the
setup function you want to change by pressing
and releasing the buttons labeled 1-9 until the
appropriate LED's are lit.
Parameters
Default
45 Degrees
5 Min
30 Degrees
3 Min
1,000 Ft
50 Ft