Garmin AIS 300 Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie morskie Garmin AIS 300. Garmin AIS 300 8 stron. Technical reference for garmin nmea 2000 products
Również dla Garmin AIS 300: Instrukcja instalacji (8 strony), Deklaracja zgodności (6 strony), Informacje techniczne (42 strony)

Drukuj stronę

Use these instructions to install the Garmin

of this package with the packing list on the box. If any pieces are missing, contact your Garmin dealer immediately.

Use the following instructions to install the AIS 300 device. Details for the following steps are included in this document:

1. Select locations for the AIS components.

2. Mount the AIS 300 receiver box.

3. Connect the AIS 300 to power.

4. Connect the AIS 300 to a VHF antenna and to an optional VHF radio

5. Connect the AIS 300 to a NMEA 2000 network or to a NMEA 0183-compatible chartplotter (optional -

When navigating, carefully compare information provided by the unit to all available navigation sources, including information from visual

sightings, local waterway rules and restrictions, and maps. For safety, always resolve any discrepancies or questions before continuing

navigation.

Use this unit only as a navigational aid. Do not attempt to use the unit for any purpose requiring precise measurement of direction, distance,

location, or topography.

Wear safety goggles and a dust mask when drilling, cutting, or sanding.

Safe Compass Distance

Ensure that you install the AIS 300 receiver box at least 15

correctly when the AIS 300 is operating.

Selecting Locations for the AIS 300 Components

Use the wiring layout diagrams starting on

cables reach all components before permanently mounting any component.

Mounting the AIS 300 Receiver Box

Install the AIS 300 receiver box below deck on a bulkhead. Select a location that is dry and protected from washdown. Ensure that the

location is well ventilated and away from objects that generate heat. Ensure that the receiver box is at least 15

compass to avoid interference.

Needed tools

• Drill and drill bits

• Number 2 Phillips screwdriver

to mount the receiver box:

1. Ensure that the chosen location is dry, protected from washdown, and well-ventilated.

2. Use the receiver box as a template, and use a pencil to mark the holes in the four corners. Do not drill through the receiver box.

3. Drill four

in. (3 mm) pilot holes.

4. Mount the receiver box using the included 20 mm M 3.5 screws. You can also use bolts, washers, and nuts (not included) to mount the

receiver box if the mounting surface is suitable.

September 2013

AIS 300 Installation Instructions

AIS 300 Automatic Identification System (AIS) Class B receiver device. Compare the contents

WARNING



CAutIoN



in. (40 cm) from any compass. Test your compass to verify that it operates

page 2

to determine how to best organize the AIS 300 components on your boat. Ensure that the

190-01178-00 Rev. D

(page

4).

page

4).

in. (40 cm) from any

Printed in China