Garmin FUSION Apollo MS-WB670 Instrukcja obsługi - Strona 40
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wyposażenie morskie Garmin FUSION Apollo MS-WB670. Garmin FUSION Apollo MS-WB670 44 stron. Marine hideaway stereo
Również dla Garmin FUSION Apollo MS-WB670: Instrukcja instalacji (19 strony)
Drukuj stronę
Network Troubleshooting
If you cannot see or connect to Fusion PartyBus devices on the network, check the following:
• Verify that only one device, either a stereo or a router, is configured as a DHCP server.
• Verify that all Fusion PartyBus devices, network switches, routers, and wireless access points are connected
to the network and turned on.
• Verify that wireless Fusion PartyBus devices are connected to a wireless router or wireless access point on
the network.
NOTE: Wired connections are more reliable than wireless connections. If possible, you should connect
devices to the network using an Ethernet cable.
• You may experience wireless interference if there are many nearby wireless access points. Change the
channel on your router or wireless access point to test for and correct interference.
• Connecting a Bluetooth device to a stereo configured as a wireless access point or client may reduce
wireless performance. Disconnect Bluetooth devices to test for and correct interference.
• If you configured static IP addresses, verify that every device has a unique IP address, that the first three
sets of numbers in the IP addresses match, and that the subnet masks on every device are identical.
• If you have made configuration changes that might be causing networking issues, reset all network settings
to the factory default values.
Network Status Icons
A network-status icon is shown on some screens of the device. You can refer to this table to understand the
appearance of the icon and help diagnose issues with the Fusion PartyBus network.
You can also observe the network status LED on the stereo for further information when troubleshooting
(Stereo Buttons and Status LEDs, page
The device is connected correctly to a network.
The device cannot detect the network. An Ethernet cable may not be connected or there may be other
problems with the network.
The stereo keeps locking up when connected to an Apple device
• Press and hold the power button to reset the stereo.
• Reset the Apple device. Go to
• Make sure you have the latest version of iTunes
The stereo is not finding my connected Apple device
• Make sure your Apple device supports Interface Accessory Protocol 2 (iAP2). This stereo is not compatible
with iAP1 devices.
• Make sure you have the latest version of iTunes and the latest operating software on your Apple device.
• Make sure you have the latest version of the Fusion-Link application on your Apple device.
• Reset the Apple device.
Go to
www.apple.com
• Contact your Fusion dealer or go to support.garmin.com.
My Apple AirPlay audio is interrupted by short breaks
• Make sure the Apple device is not covered or obstructed.
• Make sure the Apple device has a good connection to the same Wi‑Fi network as the stereo.
• Make sure the Apple device is not connected to the stereo using Bluetooth technology and Wi‑Fi.
Using both a Bluetooth and a Wi‑Fi connection may cause playback interruptions.
34
1).
www.apple.com
for more information.
for more information.
®
and the latest operating software on your Apple device.
Appendix