Garmin GDL 30A Instrukcja instalacji
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie morskie Garmin GDL 30A. Garmin GDL 30A 8 stron. Marine weather satellite receiver
Również dla Garmin GDL 30A: Instrukcja obsługi (34 strony), Instrukcja obsługi (34 strony), Instrukcja obsługi (38 strony), Instrukcja obsługi (40 strony)
GDL
™
To obtain the best possible performance, install the GDL 30A Weather Data Receiver according to the following instructions. If you experience
difficulty during the installation, contact Garmin Product Support or seek the advice of a professional installer.
Product Registration
Help us better support you by completing our online registration today! Connect to our Web site at http://my.garmin.com. Keep the original
sales receipt, or a photocopy, in a safe place.
Contact Garmin
Contact Garmin if you have any questions while using your GDL 30A. In the USA contact Garmin Product Support by phone:
(913) 397-8200 or (800) 800-1020, or go to www.garmin.com/support/.
In Europe, contact Garmin (Europe) Ltd. at +44 (0) 870.8501241 (outside the UK) or 0808 2380000 (within the UK).
WARNING: See the Important Safety and Product Information guide in the product box for product warnings and other important
information.
Important Numbers
For future reference, write down the important numbers associated with your GDL 30A. The serial number is located on the bottom of the unit.
Serial number
Unique ID numbers are associated with your GDL 30A. XM Satellite Radio™ uses these ID numbers to activate and deactivate your XM
weather and XM audio. To locate the ID numbers on a GPSMAP
30A Owner's Manual. To locate the ID numbers on a GPSMAP 4000 or 5000 Series chartplotter, select
Information.
XM WX Weather
ID
™
XM Radio ID
Packing List, Accessories, and Tools Needed
Before installing your unit, check that your package includes the following items. If any parts are missing, contact your Garmin dealer
immediately.
Standard Package
•
GDL 30A unit
•
7-pin power cable
•
Garmin Marine Network cable—6 ft. (1.8 m)
•
Documentation
•
Audio cable
•
Grommet
•
GA 32 Antenna
◦
Surface-mount bracket
◦
Pole-mount bracket
◦
Under-deck mount bracket
◦
Mounting hardware (screws and adhesive pads)
May 2008
30A XM W
eAther
D
r
i
AtA
eceiver
nstALLAtion
3000 Series chartplotter, refer to the Main Menu section of the GDL
®
Optional Accessories
•
GMS 10 network port expander
•
Garmin Marine Network cables (20 ft. and 40 ft.)
Tools Needed (Not Included)
•
Drill and drill bits
•
Fasteners (to mount the GDL 30A)
•
Hole saw, 1 in. (surface-mount cable hole)
•
Screwdriver (surface-mount screws)
•
Center punch and hammer (to mark surface-mount pilot holes)
•
Countersink bit (when mounting on fiberglass)
•
Marine sealant (for certain mounting options)
190-00930-02 Rev. B
i
nstructions
Configure > System > System
Printed in Taiwan