AEG FAVORIT 43470 I Informacje o użytkowniku - Strona 29
Przeglądaj online lub pobierz pdf Informacje o użytkowniku dla Zmywarka AEG FAVORIT 43470 I. AEG FAVORIT 43470 I 36 stron. Aeg dishwasher favorit
Connecting the dishwasher
Connecting to the water supply
• The dishwasher can be connected to cold and hot water supplies up
to max. 60°C.
• The dishwasher must not be connected to open hot water appliances
or instantaneous water heaters.
Permitted water pressure
Lowest permitted water pressure:
0,5 bar (=5 N/cm2 =50 kPa)
Highest permitted water pressure:
8 bar (=80 N/cm2 =0,8 MPa)
Connecting the inlet hose
The water inlet hose must not be kinked, crushed or entangled when it
is being connected up.
Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet
hose to a tap with an external thread (3/4 inch). The inlet hose is fitted
with either a plastic or a metal nut:
- Tighten the plastic nut hand tight only.
– You must tighten the metal nut using a tool.
Then do a visual check for water tightness (make sure that the tap is
not dripping).
• So that access to the tap in the kitchen is not limited by the use of
the dishwasher, we recommend installing an additional tap, or fitting
a T-branch to the existing tap.
Installation and connection instructions
Consult your installer if the water
pressure is less than 0,5 bar.
If the water pressure is greater than 8
bar, a pressure reduction valve must be
used (available from your dealer).
29