a-gear P1004T EPON Instrukcja instalacji sprzętu - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji sprzętu dla Bezprzewodowy punkt dostępowy a-gear P1004T EPON. a-gear P1004T EPON 13 stron. Optical network unit
Drukuj stronęA-GEAR World Wide Manufacturing
3.4.
C he c k a f te r i ns t a l l at io n
After mechanical installation of EPON access device is completed, please make the
following check before starting EPON access device:
• If EPON access device is mounted on vertical wall surface, please check the installation
reliability of EPON access device. It installed on desktop, please check if space reserved
around EPON access device is sufficient for heat dispersion and if desktop is stable or
not.
• Check if power supply connected is consistent with that required for EPON access device
or not.
• Check if the ground wire of EPON access device is properly connected or not.
• Check if EPON access device is properly connected with other equipment or not, such as
configuration terminal.
M ain te nanc e of EP O N Access Device
4.
Warning:
[1]
Before opening the equipment, ensure that static electricity that you carry has been released and power switch
of EPON access device has been turned off. Before carrying out any step in Annex B, please read the part «Safety
Suggestions»;
[2]
When you are near power supply or operate the equipment, please turn off power switch and pull of power cable
at first.
4.1.
O pe n t h e e q u ip m e n t
This part mainly describes method, tools required and operation steps for opening the cover
of EPON access device.
Warning:
When power cable is connected, do not touch it with bare hand to avoid getting an electric shock.
A-GEAR P1004T EPON Optical Network Unit (ONU)
datasheet
a-gear.net
Раge 11 of 13