AEG 6410KF Instrukcja instalacji i obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Hob AEG 6410KF. AEG 6410KF 24 stron. Electrolux ceramic hob installation and operating instructions
Również dla AEG 6410KF: Instrukcja instalacji i obsługi (24 strony), Instrukcja instalacji i obsługi (28 strony)
Drukuj stronę
What to do if ...
The cooking zones are not
functioning.
The cooking zones cannot
be selected / Appliance
does not react to the con-
trol panel input
The residual heat indicator
is not functioning
Er03
Er21
Er25
(only for 10 seconds)
3
In the event of any other fault codes that arise, disconnect the appli-
ance from the electrical supply for a few seconds (Take out the fuse
from the house's wiring system). If the fault code is displayed again,
please call your local Service Force Centre and report the fault code.
If you are unable to remedy the problem by following the above
suggestions, please contact your local Service Force Centre.
14
Problem
No cooking zone selected
More than 10 seconds has
passed since the appliance
was switched on
The child safety device is
activated
The sensor fields are partly
covered by a damp cloth or
with liquid
Safety cut-out has been
triggered
The cooking zone was only
on for a short time and is
therefore not hot
There has been a short-
term power cut.
Several sensor fields were
is displayed
touched at the same time
is displayed
Safety cut-out due to
overheating.
is displayed
Appliance is incorrectly
connected
Possible cause
l
Remedy
Select cooking zone within
10 seconds of switching on
(Decimal point lights up)
Switch on the appliance
again.
Select cooking zone within
10 seconds of switching on
Deactivate the child safety
device (See section "Child
safety device")
Remove the cloth or the
liquid
Switch on the appliance
again
If the cooking zone is hot,
contact your local Service
Force Centre.
Wait for the end of the
power cut.
Switch on the appliance.
Any residual heat is no
longer indicated.
Only touch one sensor field
Let the appliance cool
down.
Remove cookware.
Disconnect the appliance
from the electrical supply
and have it connected
properly