AEG 6562 G Instrukcja i książka instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja i książka instalacji dla Hob AEG 6562 G. AEG 6562 G 10 stron.

Drukuj stronę

Congratulations from AEG

Dear Customer,

Congratulations with your new Hob.

It is important that you become familiar with the functions and features of

the Hob. You should therefore read these operating instructions as they will

help you get the most out of your new Hob.

Pay extra attention to sections marked

you avoid accidents.

Keep the operating instructions. They will come in handy if there is

something you are not sure about, and should accompany the Hob if it is

transferred to a new owner.

The structure of the operating instructions enables you to use them as a

reference manual. The first part of the operating instructions contains a

general description of your new product. Then follows a short introduction

of the things to do before you use the Hob for the first time. The section

"How to use" describes how the Hob is used in everyday life. Use this

section until you are familiar with your new Hob. The section "Cleaning

and Maintenance" provides information on both daily and more thorough

cleaning of the individual components of the Hob. Should problems arise

when you use the Hob, you can look in the section "Before calling service",

where there are instructions on how to remedy some practical and technical

problems yourself.

Regards,

. These are warning texts to help

Enjoy!

Service

Sympton:

There is no spark when lighting the

gas?

When the operating knob is released

the gas ring goes out again?

The gas ring burns very unevenly?

Any of the following are considered to

be abnormal operation and may

require servicing:

* Yellow tipping of burner flame

* Sooting up of cooking utensils

* Burners not igniting properly

* Burners failing to remain alight

* Burner/s extiguised by cupboard

doors.

* Gas valves which are difficult to

turn.

Solution:

Check whether the 240 V connection

has been plugged in. The ground fault

circuit relay way have switched off.

The fuse has blown

The operating knob has not been

depressed long enough, or has not

been depressed sufficiently.

Ensure the cover has been replaced

correctly, e.g. after cleaning.

If service is required contact:

AEG Service Centre;

1 Stamford Road

Oakleigh Victoria 3166

Telephone 1300 650020