Brother DCP-9042CDN Podręcznik szybkiej konfiguracji - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik szybkiej konfiguracji dla Drukarka Brother DCP-9042CDN. Brother DCP-9042CDN 20 stron. Facsimile equipment
Również dla Brother DCP-9042CDN: Lista referencyjna części (43 strony), Podręcznik szybkiej konfiguracji (31 strony)
Drukuj stronę
IEC 60825-1+A2:2001 Specification
This machine is a Class 1 laser product as defined in
IEC 60825-1+A2: 2001 specifications. The label
shown below is attached in countries where it is
needed.
This machine has a Class 3B Laser Diode which
produces invisible laser radiation in the laser unit. You
should not open the scanner unit under any
circumstances.
Laser Diode
Maximum radiation power:
Wave length:
Laser class:
Warning
Use of controls, adjustments or performance of
procedures other than those specified in this manual
may result in hazardous invisible radiation exposure.
Warning
Important-For Your Safety
To ensure safe operation, the supplied three-pin plug
must be inserted only into a standard three-pin power
outlet that is properly grounded through the normal
household wiring.
Extension cords used with this printer must be three-
pin plug type and correctly wired to provide proper
grounding. Incorrectly wired extension cords may
cause personal injury and equipment damage.
The fact that the equipment operates satisfactorily
does not imply that the power is grounded and that
the installation is completely safe. For your safety, if
in any doubt about the effective grounding of the
power, call a qualified electrician.
Disconnect device
You must install this machine near a power outlet that
is easily accessible. In case of an emergency, you
must disconnect the power cord from the power outlet
to shut off the power completely.
Wiring information (U.K. only)
If you need to replace the plug fuse, fit a fuse that is
approved by ASTA to BS1362 with the same rating as
the original fuse.
Always replace the fuse cover. Never use a plug that
does not have a cover.
Warning - This machine must be earthed.
The wires in the mains lead are coloured in line with
the following code:
Green and Yellow: Earth
Blue:
Neutral
Brown:
Live
Radio interference
This product complies EN55022 (CISPR Publication
22)/Class B. When connecting the machine to a
computer, ensure that you use the following interface
cables.
A USB cable which must not exceed 2.0 metres long.
EU Directive 2002/96/EC and EN50419
This equipment is marked with the above recycling
symbol. It means that at the end of the life of the
25 mW
equipment, you must dispose of it separately at an
appropriate collection point, and not place it in the
780 - 800 nm
normal domestic unsorted waste stream. This will
Class 3B
benefit the environment for all. (European Union only)
Safety Precautions
5