AEG 88101 Instrukcja serwisowa - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Hob AEG 88101. AEG 88101 22 stron. Induction hobs
Drukuj stronę
5.3.2 Error appliance can not be operated, display indicates "0"
This error has been disappeared after a reset.
For that there were 2 fault reasons in the hardware and software, this was removed by SW Vers. 4.2
from Dec. 2004.
6 Frontline self-sufficient hobs
6.1 Special references disassembly/assembly in case of a service:
1. Disassemble appliance
Remove tension clips
2.
Open appliance
Attention! Before disassembling the glass draw off the connecting line between the user interface at the glass and
induction.
3. Replacement of display units
By means of a coin loosen plastic carriers by pressing and turning (29)
Shift back the plastic carrier until the front edge can be seen.
Lay plastic carrier to the bottom side
Remove locking bars like (30)
Draw off flat band cable
Replace electronic board
Assemble in the same way. Pay absolute attention to the correct putting and locking of the
band cable.
User interface and connection of two electronics at the glass ceramic (58 and 72 cm appliances)
(33) clamp bradings into the locking clips of the right carrier.
DGS-TDS
21.04.08
19
(29)
599 519 523 EN
(33)