AEG 99852 G Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Hob AEG 99852 G. AEG 99852 G 24 stron. Electrolux gas hob operating instructions 99852 g
Również dla AEG 99852 G: Broszura i specyfikacje (12 strony), Instrukcja obsługi (24 strony)

Drukuj stronę

Operation

Hob burners

To light a burner:

Push in the relevant control knob and turn it to maximum position.

Upon ignition, keep the knob pushed down about 5 seconds. This will allow the

"thermocouple" (fig. 1 - letter D) to be heated and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control knob to zero, and try again.

Each control knob is equipped with a pilot light which gradually lights up according to the heat

level that you select with the control knob.

When switching on the mains, after installation or a power cut, it is quite normal for the spark

generator to be activated automatically.

To ensure maximum burner efficiency, you should only use pots and pans with a flat

bottom fitting the size of the burner used (see table).

Burner

Large (ultra-rapid)

Medium (semi-rapid)

Small (Auxiliary)

As soon as a liquid starts boiling, turn down

the flame so that it will barely keep the liquid

simmering.

If you use a saucepan which is smaller than

the recommended size, the flame will spread

beyond the bottom of the vessel, causing the

handle to overheat.

Take care when frying food in hot oil or

fat, as the overheated splashes could

easily ignite.

If the control knobs become difficult to turn,

please contact your local Service Force Centre.

Using the Wok Stand

A wok stand is provided to enable you to use

a round bottomed wok on the hob. The wok

stand must only be used on the central burner,

and should not be used with any other type

of wok or pan. When fitting the wok stand,

ensure the recessesd in the frame fit securely

onto the bars of the pan supports, as shown

in figure 2.

minimum

maximum

diameter

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm

Fig. 2

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1