AEG B 99852G Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Hob AEG B 99852G. AEG B 99852G 28 stron.

Operation

Hob burners

To light a burner:

Push in the relevant control knob and turn it to

maximum position.

Upon ignition, keep the knob pushed down about

5 seconds. This will allow the "thermocouple"

(fig. 1 - letter D) to be heated and the safety device

to be switched off, otherwise the gas supply would

be interrupted.

Then adjust the flame as required.

If the burner does not ignite, turn the control knob

to zero, and try again.

If you cannot light the flame even after several

attempts, check the "cap" (lett. A) and the "crown"

(lett. B) are in the correct position.

Each control knob is equipped with a pilot light

which gradually lights up according to the heat

level that you select with the control knob.

When switching on the mains, after installation or a

power cut, it is quite normal for the spark generator

to be activated automatically.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid simmering.

If you use a saucepan which is smaller than the

recommended size, the flame will spread beyond

the bottom of the vessel, causing the handle to

overheat.

Take care when frying food in hot oil or fat,

as the overheated splashes could easily ignite.

If the control knobs become difficult to turn, please contact your local Service Force Centre.

In the absence of electricity, ignition can occur without the electrical device; in this case

approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until

it reaches the "maximum" position.

triple crown

burner

A - Burner cap

B -

Burner crown

C - Ignition electrode

D - Thermocouple