MAINTENANCE PARTS EXCHANGE
> MAINTENANCE PARTS EXCHANGE PROCEDURE :
The 2 wiper cleaners , the fan filter, the flushing tray sponge and felt pads, and the
carriage felt pads need to be replaced in the MPE procedure.
The prompt to "Exchange Maintenance Parts" will occur after
80
Wiper
(normal, powerful, or auto).
PH Cl.
Cleaner
Normally after this amount of cleanings, the wiper cleaner will be saturated to the point
Flushing
where the wiper can no longer be cleaned. When this happens, the nozzle plate will not
Sponge
be cleared and the nozzles may be blocked or the firing may be misdirected.
Roller
Felts
Menu
>
Maintenance
Fan
Filter
It is important that you use this menu and not another one to replace MPE
!
Flushing
Felt
parts because it will reset the internal counter to zero!
Display Message :
Flushing Plate Sponge Exchange
Roller Felt Exchange
Wiper Cleaner Exchange
> FLUSHING TRAY FELT & SPONGE REPLACEMENT :
REPLACE
SPONGE
+
SPARE PARTS NUMBER:
7
> Replacing Consumables on the GT3
PARTS
WIPER CLEANER
FLUSHING SPONGE
ROLLER FELTS
>
Maintenance Parts Exchange
FAN FILTER
FLUSHING FELT
> Cleaning and Replacing Consumables on the GT3
ACTION to perform :
+
+
Insert the felt into the flushing plate.
Place the sponge on top of the felt.
those 2
&
FELT
Install back the assembled flushing plate into the machine.
Check that the flushing plate is well inserted and sittting in
an horizontal position to avoid touching the PH's in move-
ment !
SB 3004001
ACTION
REPLACEMENT
REPLACEMENT
REPLACEMENT
>
OK
follow instructions and turn off printer
REPLACEMENT
REPLACEMENT
REPLACE THE FLUSHING SPONGE & FLUSHING FELT
REPLACE THE ROLLER FELT & FAN FILTER
CLEAN RUBBER CAPS & WIPER BLADES
REPLACE THE WIPER CLEANER
REPLACE THE ROLLER FELT & FAN FILTER
+
SPARE PARTS NUMBER:
TIMING
EIGHTY
head cleanings
Display:
Replace the Wiper Cleaner
Display:
Replace Flushing Plate Sponge
Display:
Replace the Roller Felt
Display:
Replace the Wiper Cleaner
Display:
Replace Flushing Plate Sponge
[to be done every weeks anyway]
SB 3005001
Drukuj stronę